Complete Tune Up Kit Fits International Harvester

One New Aftermarket Complete Tune Up Kit

Tech Info:
-(1) 4 Cylinder Spark Plug Wiring Set
–These will fit most 4 cylinder models. They have copper core wires with aluminum coating to prevent corrosion and 90 degree boots.
–Note: You must cut the wires to length and crimp the ends with a crimping tool.
–Wire lengths are approximately;
-(2) 24-3/4″ spark plug wires
-(1) 29-3/4″ spark plug wire
-(1) 34-1/2″ spark plug wire
-(1) 23-1/2″ long coil wire.
–The coil wire is made from excess wire left over from the spark plug wire.
–
–
-(1) Distributor Cap
-Only fits models using an IHC H4 magneto
-Replaces Part Number(s): 47413DYC
–
-(1) Ignition Kit
-Contains points, condensers & rotors to service H-4 Magneto
-Replaces Part Number(s): 407017R91, 407017R92
–
-(4) Spark Plugs
–M18-1.50mm thread,
–1/2″ Thread reach,
–7/8″ Hex,
–Preset Gap 0.034

Models This Part Fits:

4 Cylinder IH Models with H4 MagnetoAdditional Information: (1) 4 Cylinder Spark Plug Wiring Set -These will fit most 4 cylinder models. They have copper core wires with aluminum coating to prevent corrosion and 90 degree boots. -Note: You must cut the wires to length and crimp the ends with a crimping tool. -Wire lengths are approximately; (2) 24-3/4″ spark plug wires (1) 29-3/4″ spark plug wire (1) 34-1/2″ spark plug wire (1) 23-1/2″ long coil wire. -The coil wire is made from excess wire left over from the spark plug wire. (1) Distributor Cap Only fits models using an IHC H4 magneto Replaces Part Number(s): 47413DYC (1) Ignition Kit Contains points, condensers & rotors to service H-4 Magneto Replaces Part Number(s): 407017R91, 407017R92 (4) Spark Plugs -M18-1.50mm thread, -1/2″ Thread reach, -7/8″ Hex, -Preset Gap 0.034″, -Medium hot, -Power tip / Non-Resistor